Zeta Adventure Armor-Guard Handguards

Zeta Adventure Armor-Guard Handguards

The shortest path between two points is a straight line. Zeta Armor Guards take the squiggly fun route. The sweeping contour exits your bar end at a downward slope to cause less of an interference with the outside of your hand when you're riding elbows up. Depending on your bike setup, this downward slope can also provide more lever coverage in the case of side impacts. The rigid 7000-series aluminum guard then curves upward to face trail obstacles head on. Finally, the path heads outward so the inward bar mount avoids any exiting cables or hydraulic lines from your levers. 

This special Adventure bend and overall length is designed to accommodate the controls found on most adventure touring motorcycles as well as their fixed-position windscreens. A bar end spacer and 2-position inward bar mount further enable various installation configurations.  

Features:

• 7000-series aluminum construction
• Anodized finish
• Pre-drilled for mounting plastic shields
• Mounting hardware included
• Sold as a pair

Note: Hardware kit only - NO plastic guards included. Not compatible with over-sized handlebars (bars that increase in diameter towards the center of the bar).