Stockton X Adam's Supreme Foam Wash

Stockton X Adam's Supreme Foam Wash

Stockton by Adam's Supreme Foam Wash provides a gentle, pH-neutral clean. Its thick foam lubrication minimizes scratches, whether using a foam cannon or bucket wash.

Foam Cannon Instructions

Step 1:

Make all necessary checks and connections for your pressure washer to ensure proper use.

Step 2:

Fill foam cannon or foam gun canister approximately 4/5 full with clean water.

Step 3:

Pour 1-2 oz. of Supreme Foam Wash into canister (approx 20:1 ratio). Pro Tip: 1 capful is approximately 0.4 oz. 

Step 4:

Screw foam cannon or foam gun barrel onto canister, shake well. Set your foam cannon or foam gun to maximum foam. For maximum suds with use with a foam gun we recommend NOT using a metering tip.

Step 5:

Pre-rinse bike with pressure washer to remove heavy dirt, mud and other debris from the surface.

Step 6:

Attach foam cannon canister and sprayer to the pressure washer wand. For use with foam gun, attach to a hose nozzle.

Step 7:

Squeeze the pressure washer handle to spray a clinging foam solution onto the bike.

Step 8:

Allow Supreme Foam Wash to pre-soak vehicle, helping to loosen and lift dirt. Lather the bike with a soft and clean wash mitt, routinely rinsing to remove debris.

Step 9:

Rinse and dry the bike - for that factory showroom shine, finish it off with your favorite Stockton x Adam's detailing products.

Bucket Washing Instructions

Step 1: Thoroughly rinse bucket and wash mitts of all debris.

Step 2: Add 1-2 ounces of Supreme Foam Wash to bucket and fill with 2-3 gallons of water.

Step 3: Rinse bike of all heavy debris and dirt.

Step 4: Generously lather bike with soaked wash mitt, routinely rinsing in bucket to remove debris.

Step 5: Rinse and dry the bike.

Common Sense Warning

FULLY ALLOW BIKE TO COOL BEFORE WASHING. If it's too hot to touch it's too hot to wash. Not only do you risk hurting yourself but you also risk ruining the finish of your bike/exhaust/engine if the bike is hot while washing. If your bike is ceramic coated or has a fresh application of sealant or wax, please note that the foam may not cling to the slick surface as well. IMPORTANT: Foam cannons must be cleaned after every use to avoid clogging. Fill the canister with water only, then spray it through the pressure washer for at least 1 minute to ensure Supreme Foam Wash residue is fully removed from the foam cannon internals. Failure to rinse it out can cause soap to dry and clog the cannon.