ODI Emig V2 Lock On Grips

The ODI Lock-On Grip System allows you to change or replace your grips in seconds without the need for any wire ties or glue. Utilizing an OE spec throttle tube with a Snap On Cam System, the grip comes molded directly to the plastic tube, allowing you to replace your grip along with the entire throttle tube. On the clutch side, the grip is also molded to a plastic tube that features a lock jaw clamp to secure the grip to the bars. Slide the tube into position and tighten the pre-installed clamp and you are ready to ride in seconds.

Note: See resources tab for throttle cam fitment information. Some models require a cam that must be purchased separately. 

Features:

• Medium diameter knurled pattern EMIG Design includes special half-waffle pattern with thumb relief
• 100% Slip-free performance guaranteed
• Simple installation and removal without waiting for glue to dry
• Knockout ends easily accommodate handguards
• No safety wire required means longer grip life, even in the event of a crash
• Fits 7/8" bars or over-sized bars that taper to 7/8" at control ends
• Includes throttle tube and full sized modern MX 4-stroke cams B, J, K and M, along with 2-stroke cams C and D
• Made in the USA